#Download winlink express download

For the SignaLink USB this should be NONE.

This can use a lot of computer resources, so you may not want to check this.

Homebrew interface: select your soundcard input and output connected to your interface.

SignaLink USB: Select USB Audio CODEC for both Output and Input devices.

On the SoundModem screen, click Settings/Devices.

You may get a message from your Anti-Virus program.

Unzip the file and copy the soundmodem.exe to a convenient folder.

There are some other files you can download, but that one is the only one you need to run the program.

#Download winlink express download

Go to and download the file soundmodemXX.zip.

Particularly with respect to the Windows system sound settings. It assumes that the SignaLink USB has been set up correctly as shown in the SignaLink operation and instruction manual. This procedure applies to use of the SignaLink USB for VHF Packet.

W6CCDвЂ™s instructions have been modified slightly to account for homebrew soundcard interfaces. You can monitor all packets on frequency using the UZ7HO Soundmodem just as you did with AGW PE / UISS.

Unless you are an AGW PE die hard or have a real good reason to stick with AGW Express, it is recommended you migrate to the UZ7HO solution. AGW Express is still available on this site in the original Soundcard WinLink post ( Link ) but is in no way supported by SERC, or anyone else. The AGW Express / AGW PE setup had other uses such as running UISS by ON6MU to monitor the packet frequencies or to run TNCs not supported by WL Express such as the KPC-2.

UZ7HO version 0.96b and above has changed the Settings/Modem Mode from вЂњVHF AX.25 1200bdвЂќ to вЂњAFSK AX.25 1200bdвЂќ.ДЄGW Express by W2YG is no longer supported due to changes in Winlink Express (formerly RMS Express) that now allows the use of the UZ7HO Sound Modem. For soundcard packet the signal bar on the waterfall should be centered at 1700